Cobalt™ SeriesBLUE LASER
– Kit with all the parts needed to construct a
2,000mw (445nm) BLUE
LASER.
Kit
uses proprietary diode making it The
World's Most Powerful Hand-Held LASER.
Included in the
Kit
will be:
1 Solarforce™ Flashlight
host w/Tail
cap switch
1
Proprietary
LASER diode (encapsulated in the Pill)
1
Proprietary
Linear Buck / Boost Driver
(encapsulated in the Pill)
1 Diode Mount / Heat Sink/
collimator Lens Assembly
2 #18650 3.6Volt Batteries
1 Dual Battery Charger<2,000 milliwatt 445nm>
1 Belt Holster
1 Detailed step-by-step Instructions
(written in English; not "Chinklish")
Power Output Certification for the serially-numbered LASER
<2,000 milliwatt 445nm>
Pill which in Military terminology is
known as a FRU
Tired of
waiting for a LASER from WickedLASERS?
Perhaps you should consider an alternative.
When you
complete the order process, before we ship your LASER
Kit to you, we
will call you and / or email you with a tracking number.
Each LASER
Kit features a pre-assembled, tested, and certificate-certified power
output LASER Pill that is ready to
install into the Host flashlight
body. Our proprietary linear buck /
boost driver powers our proprietary LASER LED to its maximum rated
capacity.
Sold as an
easy-to-assemble Kit – requiring
no soldering or special skills other
than reading a sheet of instructions, this LASER is sure to take the LASER
hobby community by storm.
This LASER is CERTIFIED POWER <2,000mw
TEM00 CW 445nm Blue.
Using entirely proprietary parts in a
Solarforce™ flashlight
host, this is currently – albeit
unofficially –
the most powerful hand-held production
LASER Kit on the planet... BAR NONE!
With our proprietary driver, you can
"piggyback" SIX (6) # 18650 batteries for super-long operating time and
the most AWESOME-Looking LASER Build anyone has ever thought of.
Shown Approximately Actual Size
Cobalt 2000 Prototype in Ultrafire
Host
- Burns a hole in a business card in 3 to 4
seconds, and when the LASER is removed, the card slowly burns to ashes.
The
form-factor of this LASER is tiny compared to Wicked Laser's Arctic. In
its single tube configuration, it
is easy to carry, inconspicuous, lightweight, and can be mounted on a
Picatinny Rail.
In its
single extension tube (standard) configuration, this LASER will operate on up
to SIX # 18650 batteries (additional extension tubes needed). The LASER
Pill driver will accept battery configurations / combinations supplying
5.2 to 36 VDC. The more voltage supplied, the less current is drawn from
the batteries, and the longer the batteries will last before they need
to be recharged.
Our
prototype design Cobalt 1000 (This one measured at 983mw, which is
typical of those being produced) LASER burns a hole in a business
card in 5 to 6 seconds. This is not so amazing as what happens after
the LASER is removed; the card continues to burn as if the molecules in
the card were heated so hot that the smoldering and burning continues
until the card turns completely to ashes.
Maybe it's the card?
*
Assembly of multiple component parts is required for non-military customers.
We provide a complete set of pre-assembled FRU
components and a set of detailed instructions that will enable you to
assemble this LASER easily. We will also assist you over the phone if you
have any questions or difficulties. No tools or electronic experience is
required.